This Corvette reproduction antenna nut has been manufactured to original factory specifications using today's modern manufacturing techniques. You will find the fit, finish and function will work superbly for your…
Reproduction Of Original Round 30 Non-Retractable AM/FM. This Chevrolet reproduction antenna mast has been manufactured to original factory specifications using today's modern manufacturing techniques. You will find the fit, finish and…
When restoring or repairing the antenna of a wide selection of General Motors cars and trucks including the Chevrolet Corvette, this antenna bezel gasket is a direct fit replacement for original equipment.
Compatible for use…
Tapered mast as original (.100 at ball; .185 at mast).
Has correct .305 size ball.
This stainless steel antenna mast measures 31 1/2 inches overall length, with a thread size of 1/4 inch x 20.
…
Replacement Bezel
This Corvette replacement antenna bezel has been manufactured to meet or exceed factory specifications and performance. You will find the fit and finish will work perfectly for your Chevy.
…
Black shouldered gasket comes with the correct indexing mark and keeps the chrome antenna bezel from scratching the fresh paint job on top of your Camaro fender or rear quarter panel.
…
Stock Replacement Fits 1969-75 Front Fits 1969 Rear This stock replacement antenna bezel nut is manufactured by GM or by one of its authorized suppliers for use as a factory replacement part. You will find the fit, finish and function…
Stock Replacement For Use With Antenna In Windshield Style El Camino's This stock replacement antenna lead wire is manufactured by GM or by one of its authorized suppliers for use as a factory replacement part. You will find the fit…
Reproduction Of Original Used On Front Fender Antenna Don't forget to give your 1967-68 Camaro that finished look and replace that corroded antenna nut. A simple install but makes a big difference in your Camaro appearance.
…
Reproduction Of Original Fits 1965-69 Front Fits 1965-67 Rear Replaces GM# 3863499 This Chevelle reproduction antenna mast nut has been manufactured to original factory specifications using today's modern manufacturing techniques. You will…
Correct reproduction zinc diecast chrome plated antenna nut used on all 65-68 Corvettes.
This antenna nut cap has the correct flats on the side of the nut and stepped lower edge where the nut mounts on top of the antenna bezel.
Hole…
Stock Replacement For Use With Antenna In Windshield Installs On The Upper Cowl Panel Correct Stamped Steel Ends 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979 Nova's are great to restore and fun to drive, the only thing better…
These are replacement mast assemblies for our RetroSound fully automatic power antennas. Included are the mast and gear assembly.
NOTE: These will not work with any other antennas except for RetroSound antennas
…
Best Quality Reproduction Antenna Gasket Fits Rear Antenna, Left Or Right Oval Just Like The Original GM Gasket Not A Generic One Size Fits All The antenna base or bezel gasket seal keeps the antenna from scratching the paint on your…
Reproduction Of Original
The mast section of the antenna consists of four round chrome sections, three telescoping sections, and one fixed section, with an approximately 1/4" ball-shaped tip at the end of the mast. The overall…