Front spoiler designed for 1970–1973 Chevrolet Camaro Rally Sport models to restore authentic RS styling while improving front-end protection and aerodynamic stability. This durable reproduction mounts to the front valance to reduce lift, shield the lower bumper area from road debris, and complete a period-correct restoration. Engineered for long-lasting performance and a clean factory appearance, it provides a straightforward solution for enthusiasts replacing a damaged original or finishing a restoration project.
Features:
- Fitment: 1970-1973 Chevrolet Camaro Rally Sport (RS) models.
- Restores original RS front-end appearance for restorations and show cars.
- Constructed from impact-resistant material for durability and longevity.
- Helps reduce front-end lift and protects the lower bumper/valance from road damage.
- Designed for a close factory-style fit and easy finishing (paintable).
- Bolt-on installation with OE-style mounting locations for a secure fit.
Installation / Application:
- Difficulty: 2/5
- Estimated time: 1-2 hours
Instructions:
- Park vehicle on level ground, engage parking brake, and support front end with jack stands or ramps if needed for access.
- Inspect the bumper valance and mounting area; remove any damaged or loose original parts and clean the surface of dirt and rust.
- Test-fit the spoiler to the valance to verify alignment with existing holes and bodylines. Use masking tape to protect painted surfaces during fitment.
- If required, mark any new hole locations on the valance while holding the spoiler in position. Transfer marks from the spoiler to the valance using a center punch.
- Drill pilot holes at marked locations if the vehicle lacks existing mounting holes. Start with a small bit and enlarge as needed to match fastener size.
- Attach the spoiler using the appropriate fasteners through the valance into the spoiler mounting points. Hand-start all fasteners to ensure alignment before final tightening.
- Tighten fasteners evenly to secure the spoiler, taking care not to overtighten and deform the part. Use a torque wrench if torque specifications are available.
- Verify final alignment and gaps. Touch up any installation scuffs and finish the spoiler with paint if necessary following proper surface preparation and paint instructions.
- Re-check hardware after a short test drive and retorque if necessary.
Vehicle Fitment:
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
| Make |
Model |
Years |
| Chevrolet |
Camaro |
1970 - 1973 |
