This easy mounting kit provides a 20 amp protection fuse block. It mounts to the starter switch using the same holes. Instructions are included. A highly recommended safety feature to provide a fuse not originally offered on Model…
Not factory original, but extremely effective in shielding starter from manifold heat. Manufactured in stainless steel, fits all small and big block. Use STR-16 Retaining Nut.
…
Replacement Starter Bolts Outside Diameter: .370 Shaft Length: 3.600 Overall Length: 3.975 These Camaro replacement starter bolts has been manufactured to meet or exceed factory specifications and performance. You will find the fit and…
Reproduction Of Original Correct Big Block Bolt Set Outside Diameter .370 Shaft Length 3.600 Overall Length 3.975 These Chevelle reproduction starter bolts have been manufactured to original factory specifications using today's modern…
We have the original starter mounting volts for the small block Ford applications. These bolts feature the 1/2 Wrenching size required for clearance to properly install the tight fitting 289, 302, and 351 starter. The bolts also include an…
Authentic hardware you need to correctly reassemble the engine components. Most fasteners have correct markings for the time period. This four-piece kit includes 3.62 long hex bolts, hex bolt and washer assembly and nut.
…
Starter Heat Shield? Provides Protection By Reflecting 90% Of Radiant Heat, Up To 2000F Eliminate starter problems caused by close proximity of the exhaust to the starter with Thermo-Tec Starter Heat Shield?. The radiant heat of the…
Manufactured in stainless steel as original in the USA. Technically correct reproduction starter heat shield found on all big blocks (GM# 3954224). For the demanding restorer.
…
Stock Replacement Original GM Part Supports The Starter To The Engine Block Critical For Proper Starter Operation This stock replacement starter brace is manufactured by GM or by one of its authorized suppliers for use as a factory…
We have the original starter mounting bolts for the small block Ford applications. These bolts feature the 1/2 Wrenching size required for clearance to properly install the tight fitting 289, 302, and 351 starter. The bolts also include an…
Aluminum heat shields are a must for any Chevy race engine. Prevents the heat of your exhaust from cooking the starter and solenoid. Easy to install.
396, 402, 427, 454, 496, 502, 572, 5.43" Overall Length
Polished or raw finish…
Starter Terminal Nut
Brass Construction
Correct OEM Length
Correct OEM Thread Pitch
Made In The U.S.A.
This is a brass nut that attaches the cable to the starter terminal on your Model T. Made in the…
Starter Bendix Drive Key
Inserts Into Keyway On Starter Shaft
Correct OEM Size & Dimensions
High Quality Seel
Made In The U.S.A.
This is the proper sized Bendix drive key for holding the starter gear on the…