This front right-hand floor pan section with integrated toe board is a direct-fit replacement for 1973–1977 GM A-Body cars (Chevelle, Malibu, Cutlass, Monte Carlo, Skylark, LeMans). It restores structural integrity to the passenger-side footwell, replaces rusted or damaged metal, and provides correct OEM contours for carpet, pedals, and seat mounts. Built from stamped steel and engineered for weld-in installation, the panel improves vehicle safety and longevity while offering a durable, corrosion-resistant foundation for restoration projects.
Features:
- Fits 1973-1977 GM A-Body vehicles (Chevelle, Malibu, Cutlass, Monte Carlo, Skylark, LeMans) — front right-hand (passenger) side.
- Stamped steel construction for OEM-style fit and strength.
- Integrated toe board restores original contours and mounting points.
- Direct weld-in replacement designed to replace rusted or damaged floor sections.
- Pre-formed edges and contours reduce fitment time and alignment issues.
- Improves structural rigidity and protects against future corrosion when sealed and coated.
- Ideal for restorations, collision repairs, and rusted-floor replacements.
Installation / Application:
- Difficulty: 3/5
- Estimated time: 2-4 hours (vehicle dependent)
Instructions:
- Prepare vehicle: disconnect battery, remove seat, carpet, trim, and any components covering the affected area.
- Inspect and mark the damaged floor area. Measure and test-fit the replacement panel to confirm coverage and alignment.
- Remove the old floor section: grind out spot welds or cut away rusted metal, keeping solid surrounding metal intact where possible.
- Clean and prep mating surfaces: remove rust, paint, and debris. Ensure edges are straight and provide good metal-to-metal contact.
- Trial-fit the new panel and make any minor trim adjustments for proper fit. Use clamps to hold the panel in position.
- Weld the panel in place using stitch or plug welds at factory weld points. Avoid long continuous welds to reduce distortion; weld in short increments.
- Grind welds smooth as needed. Use hammer and dolly to restore any contours and ensure a flush fit with the surrounding floor.
- Apply seam sealer to all exposed seams and joints. Prime bare metal with rust-inhibiting primer, then finish with undercoating or paint as desired.
- Reinstall carpet, trim, seats, and any removed components. Reconnect the battery and perform a final inspection for secure fitment and proper sealing.
Vehicle Fitment:
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
| Make |
Model |
Years |
| Buick |
Century |
1973 - 1977 |
| Buick |
Regal |
1973 - 1977 |
| Chevrolet |
Chevelle |
1973 |
| Chevrolet |
El Camino |
1973 - 1977 |
| Chevrolet |
Laguna |
1973 - 1976 |
| Chevrolet |
Malibu |
1973 - 1977 |
| GMC |
Sprint |
1973 - 1977 |
| Oldsmobile |
Cutlass Supreme |
1973 - 1977 |
| Oldsmobile |
Cutlass |
1973 - 1975 |
| Oldsmobile |
Vista Cruiser |
1973 - 1975 |
| Pontiac |
Grand Am |
1973 - 1975 |
| Pontiac |
Grand Prix |
1973 - 1977 |
| Pontiac |
LeMans |
1973 - 1977 |
