Chevelle Suspension Front Tubular Arms, Upper, Stock Width,1964-1972
Chevelle Suspension Front Tubular Arms, Upper, Stock Width,1964-1972

Chevelle Suspension Front Tubular Arms, Upper, Stock Width,1964-1972

$653.99 pr
Model:3029855
Condition: NEW
Availability:
ARRIVING SOON!
Estimated arrival: 05/18/2021 (If Ordered Today)
Fitment:
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
Shipping Note:Oversize 1
Qty:

Can't Find your Part?

We'll find it for you. Give us a call at 855.444.6872 and we'll source that discontinued or hard to find part.

Why Choose Us?

No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.

Disclaimer

Muscle Cars & Classics always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.

CPP?s Tubular Control Arms are designed to provide full wheel travel and minimal friction. The upper control arms are made from 1-1/4? x .120? wall and the lower is 1-1/2? x .120 wall D.O.M. tubing and the pivot barrels are thick 1-1/2? .188? wall D.O.M. tubing to eliminate distortion from welding and hard use. The upper control arms allow for 5 degrees of caster. The lower arms provide increased ground clearance and allow the use of sway bars. They can be installed with either factory uppers and lowers, or as a full set. The bushings are made from self lubricating non-squeak patented plastic that will out last any rubber or urethane, and works at temperatures in excess of 400 degrees F. The Chrome-moly cross shafts and sleeves are zinc plated for lasting performance. The sleeves have an interlocking design that prevents the hardware from ever working loose. The pivots carry both forward and back loads (the original cross shaft pivot was designed to only carry a forward or back load, but not both). The control arm assemblies are a simple bolt-in installation with no modification required. They work with all factory and replacement

The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
Make Model Years
Chevrolet Chevelle 1964 - 1972
Chevrolet Estate 1969 - 1970
Chevrolet Malibu 1964 - 1967

Write a Review

Your Name:

Your Review:

Note: HTML is not translated!

Rating: Bad Good

Ask a question about

Chevelle Suspension Front Tubular Arms, Upper, Stock Width,1964-1972:
Your Name:


Your Email:


Question: Note: HTML is not translated!

Related Products
Shipped from Canada
No Brokerage or Duties
Canadian Owned
www.musclecarsandclassics.ca 2021