Estimated arrival: 08/11/2021 (If Ordered Today)
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Standard Delivery|
We'll find it for you. Give us a call at 855.444.6872 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Muscle Cars & Classics always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Our rear adjustable control arms for your Chevelle make setting pinion angle easy. The control arm is designed with right and left-hand threads on the adjuster so the arm does not have to be removed in order to adjust the length. Jam nuts secure the position after adjustment. Adjustable upper arms are required if you are installing a nine inch Ford rear end. High misalignment spherical bearings are located on the frame side allowing the rear end to have proper movement. The rear end upper pivot mounts, for street and handling applications, should use rubber bushings. NOTE: if you use polyurethane bushings on the rear end upper mounts, the rear end of your Chevelle will go into bind at the outer limits of travel. Rubber will allow for any additional movement required.
|Chevrolet||Chevelle||1964 - 1967|
|Chevrolet||Malibu||1964 - 1967|
Note: HTML is not translated!
Rating: Bad Good