855.444.6872 Contact Us Mon-Fri 10a-6p & Sat 10a-3p EST
DRIVEN BY CARE

Camaro Radiator Hose Clamp, Upper, Tower Style, 1967-1969

Camaro Radiator Hose Clamp, Upper, Tower Style, 1967-1969
Camaro Radiator Hose Clamp, Upper, Tower Style, 1967-1969
$5.99 ea
NEWIN STOCK18 Units in Stock
Model: 2029681
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
STANDARD
DELIVERY
STORE PICKUP
[More Info]

Tower clamps like this were used on all 1967-69 Camaro radiator hoses from the factory and being cold galvanized they were very susceptible to rust and corrosion.

Tip: Use a crescent type wrench at the square nut to hold it so it and the clamp do not twist when tightening.  Then after a few heat cycles repeat. Also, if the bent tabs that are on the clamp are crooked, you may have to straighten them out. You may have to reinstall these clamps multiple times until you get a good fitment.  Also, the GM AIM makes not of using a sealer inside the heater hoses when using Tower Clamps.  You can run a bead of Permatex inside the hose.

Vehicle Fitment:

The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
Make Model Years
Chevrolet Camaro 1967 - 1976

Reviews:

Write a Review
* Your Name:
* Email (This will not be displayed)
* Rating:
Comments:

Ask a question about

Camaro Radiator Hose Clamp, Upper, Tower Style, 1967-1969:
Muscle Cars & Classics 2023